Priming your Cabinet Style Soft Serve Machine

 
Learn how to sanitize and prime your Taylor 8756 cabinet style freezer
 

Priming your Taylor Soft Serve - Cabinet Style Freezer

Step 1 Place the mix tank and the cover in the mix cabinet.

Step 2 Insert the prongs of the mix probe inside the mix tank. Connect the mix probe in the socket receptacle.

Step 3 Place the free end of the suction line into the mix tank.

Step 4 Install the funnel. Fill the mix tank with fresh mix.

Step 5 Remove the funnel and install the mix storage cover. Close the mix cabinet door.

Step 6 Place an empty pail beneath the door spout and open the draw valve. With the prime plug still in the UP position, press the PUMP key. This will allow the mix to be pumped through the freezing cylinder and force out any remaining sanitizer. When full strength mix is flowing from the door spout, close the draw valve.

Step 7 When a steady stream of mix is flowing from the prime plug hole in the bottom of the freezer door, press the PUMP key to stop operation.

Step 8 Once the stream of mix stops flowing from the prime plug hole, push down the prime plug. Rinse the prime plug hole area with water. Remove the pail and discard the mix and sanitizer.

Step 9 Press the AUTO key. The MIX REF indicator will illuminate to indicate the mix refrigeration system is operating. The AUTO indicator will illuminate to indicate that the main refrigeration system is operating. The PUMP indicator will illuminate to indicate that the air/mix pump will operate whenever mix is needed in the freezing cylinder.

Repeat these steps for the other side of the freezer.